200w 220v RYT201 D5-VS2 FUJI SERVO DRIVE, 1 - Phase

Product Details

Do not touch the inside of the servo amplifier. There is a risk of electric shock. Make sure to ground the grounding terminal of the servo amplifier and servomotor. There is a risk of electric shock. Before performing wiring or inspection, turn the power off and wait for at least five minutes, and check that the charge LED is unlit. There is a risk of electric shock. If the charge LED is off even though the power is turnd on, the fuse inside the servo amplifier may be blown. To check the fuse, wait five minutes or more after turning off the power. There is a risk of electric shock. Do not give damage or unreasonable stress to cables. Do not place a heavy matter on them or do not pinch them. It might cause failure, breakage and electric shock. Do not touch the rotating part of the servomotor during operation. It might cause injuries.  Caution:   Use the servomotor and servo amplifier in a designated set. It might cause fire and failure. Perform the wiring correctly and firmly. It might cause failure. Never use at places susceptible to water splashes, in corrosive atmosphere, in flammable gas atmosphere or near flammable matters. It might cause fire and failure. As the servo amplifier, servomotor and peripheral devices temperature will become high and requires careful considerations. There is a risk of burns. Do not touch the heat sink of the servo amplifier, regenerative resistor, servomotor and so on while they are turned on and for a while after they are turned off due to high temperature. There is a risk of burns. If the surface temperature of the servomotor exceeds 70°C during operation of the servomotor of the final assembly, affix a "hot" caution label. If a regenerative resistor is used, take measures to turn the power off upon a fault signal output from the servo amplifier. Otherwise the regenerative gresistor may be overheated and cause fire in the event of failure of the regenerative transistor. Do not store at places susceptible to rain or water splashes or toxic gases or liquid. It might cause failure. Store at places without direct sunshine within the predetermined temperature and humidity range (between -20°C and +60°C, between 10% and 90% RH, without condensation). It might cause failure. To store in the installed state. Cover the entire servomotor with a sheet to protect against vapor, oil and water. Apply an anticorrosive agent on machined surfaces such as the shaft and flange face. To avoid rust on bearings, turn manually or operate for five minutes without a load about once a month.  Do not hold cables or motor shaft when transporting. It might cause failure and injuries. Overloaded products will cause collapse of cargo, hence observe the requirements. The eye bolt of the servomotor shall be applied exclusively for transportation of the servomotor. Do not use it to transport machineries. It might cause failure and injuries. For detailed description regarding lithium batteries, refer to "CHAPTER 15. APPENDIXES." Fumigation process before shipment The internal parts of servo amplifiers may get corroded due to a halogen compound gas such as methyl bromide which is used for fumigation process in packaging, resulting in damage of the product. When shipping servo amplifiers by installing them to a board or unit, pack them using wooden materials which have been processed with fumigation treatment.  Do not ride on the servomotor or place a heavy matter on it. It might cause failure, breakage, electric shock and injuries. Do not block the exhaust port or do not allow foreign substance to enter. It might cause fire and electric shock.