Anabond 666t Max Gasket Sealant 25gm, Grade Standard: Industrial Grade, Pack Size: 100g

Product Details

Technology Silicone Chemical type Oxime silicone Appearance Thixotropic paste ColourClear Components One component – requires no mixingCureRoom temperature vulcanizing (RTV) Application Bonding /SealingAnabond 666T Max gasket sealant is a single component, non-slumping, low odour, low volatile silicone adhesive/sealant. It is designed to provide reliable "formed-in-place" gaskets for mechanical assemblies where high temperatures are experienced. The material cures on exposure to moisture in the air to form a tough, flexible, silicone rubber gasket. The product resists aging, weathering and thermal cycling without hardening, shrinking or cracking. It has good adhesion to substrates like aluminium, mild steel, glass, ceramics, corks and many plastics.This is a universal gasket maker and it meets every sealing need in automobile engine, timing covers, oil sump applications, valve covers, rocker covers, water pumps, end seals, intake manifolds and rear axle housings. Also used as a sealant and adhesive for assembly and repair of industrial furnaces, ovens, boilers, exhaust stacks, high temperature ducting, bonding of sensitive electronic components and sub assemblies.Typical Properties of uncured materialSpecific gravity at 30 ± 2°C ATM*-R004 (JIS* K6820) 1.02 -1.06Flow, sag or slump at 30 ± 2°CATM-R016 (ASTM* C639)Non sag Extrusion rate for 20g at 30 ± 2°C, orifice 2.6, pressure 3.0 kg/cm2, ATM-R047 (BS* 5889) seconds 10 - 20Pressure resistance at 30±2°C, ATM-R034 (JIS K6820)kg/cm2≥ 100 Flash Point Refer MSDSCuring performanceThe product cures on exposure to moisture in the air, typically developing a skin within minutes, becoming tack free within minutes to hours. After skin formation, cure continues inward from the surface. Optimum physical properties are reached after curing for 7 days at 30±2°C, 55±5% RH.The rate of surface/depth cure depends on the relative humidity and temperature of the environment, thickness of the adhesive and the area under the joint. Curing time is extended at lower humidity levels.Curing tested at 30 ± 20C, 55 ± 5% RHSkin forming time – Surface cure, ATM-R017 minutes 3 - 8Depth cure, ATM-R015.mm/day≥ 3.0 Operating parametersApplication temperature ???C 10 to 40In service temperature???C-50 to +230 Short exposure ???C 250Typical properties of cured materialCured for 7 days at 30 ± 20C, 55±5% RHPhysical PropertiesTensile Strength, ATM-R020 (ASTM D412) kg/cm² 10 - 20Elongation,ATM-R020 (ASTM D412)%≥ 300 Durometer Hardness, ATM-R019 (ASTM D2240) Shore A 25 - 35 Electrical PropertiesDielectric strength, ATM R119 (ASTM D149) kV/mm ≥ 18General InformationThis product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be selected as a sealant for chlorine or other strong oxidizing materials.HandlingBefore handling, read product safety data sheets (MSDS) and container labels for safe use.