Atlantis Big Plus Hot Normal And Cold Floor Standing Water Dispenser with RO Kit

Product Details

Operating Instructions:Initial Product Cleaning ProcedureAs with most new appliances, it is recommended to clean the reservoir prior to rst time use.Make sure the unit is unplugged and power switch is turned off.Remove the bottle support funnel, saturate a clean cloth with water dispenser cleaner or vinegar and wipe the inside of the reservoir.Pour water dispenser cleaner or a mixture of 0.3 gal / 1 L of vinegar with 0.3 gal / 1 L of hot water into the reservoir and wait 20 minutes.Important: To avoid water over ow while cleaning the dispenser, always remove the bottle support funnel before pouring water or cleaning solution into the reservoir.Press all dispensing buttons until water no longer comes out.Drain the reservoirs from the drain valve on the back of the unit. (in hot & cold unit only)Rinse again with clean water.Place bottle support funnel back on top of dispenser.Installing The Water Bottle:Important: Always wash your hands rst! Clean the top (neck) of the bottle with a clean cloth and do not touch the part of the unit that the water touches.Make sure the unit is unplugged and power switch is in the OFF position.The water bottle can be purchased from your local retailer.Remove the protective cap from the end of the water bottle unless the bottle has a puncturable cap or sticker.Lift and turn the bottle upside down, placing it securely on the bottle support funnelPress and hold all dispenser buttons until water  ows from the dispenser.Drain about 0.3 gal / 1 L of water before initial use. This does not need to be repeated with replacement bottles.Plug in the water dispenser.Set the power switch at the rear of the dispenser to the ON positionReady-to-dispense indicator lights will come on when water reaches optimum temperatures and is ready for use. Cleaning And Maintenance:Like most appliances, your new water dispenser requires periodic maintenance to operate efficiently. Your water dispenser must be cleaned every 4 months. Please note that as per your warranty, routine maintenance of the dispenser is required. Failure to maintain the water dispenser will void your warranty. Cleaning Your Water Dispenser:Important:Make sure you turn the power switch to the OFF position and unplug the dispenser before performing any of the following cleaning procedures. Cleaning The Outside Of The Water Dispenser:The outside of the dispenser can be wiped clean with water dispenser cleaning solution or a mild soap and water. Never use harsh chemicals or abrasive cleaners. Rinse thoroughly with clean water and then dry surfaces.Cleaning The Drip Tray:To remove, take the grill off the tray and rmly lift the tray up, dislodging it from the guides. Drain and clean. The drip tray should be emptied and cleaned regularly to remove spotting and any mineral deposits. Clean with water dispenser cleaning solution or a mild soap and water. For tough deposits, add vinegar and let it soak until the deposits come loose. Then wash, rinse and dry thoroughly. To replace, put the grill back on the tray and slide the tray onto the guides.