Dr.Fixit Fevimate XL Tile Adhesive, Bag, Packaging Size: 20 kg

Product Details

Dr. Fixit Fevimate XLis tile adhesive for large tiles and low porous tiles. It is used for fixing of tiles internally & externally over walls & floors with excellent bond on cementitious surfaces.Dr. Fixit Fevimate XLis composed of ordinary Portland cement properly selected & graded aggregates, polymer, rheology modifier & additives.Area of Application Suitable for large tiles and low porous tiles such as Ceramic tile, Porcelains, Granite, Marblesand Glass Mosaics Suitable area where contact to water such as bathroom, kitchen room, pond, swimming pool.Rate of Uses* Theoretical consumption without allowance for loss (20 kg.) with Clean Water 4.6 liter (23%)  3-7 Sqm /bag (depending on tile sizes weights, and substrates)Method of Application1. Surface preparation All surfaces must be structurally sound, dry, clean and free from movement, oil, grease, wax, curing compounds, any other loose contaminating materials New concrete must be allowed to cure for at least 28 days and have a wood float finish Newly rendered/screenedsurfaces must be allowed to cure for at least 7 days and have wood float finish Street trowel finished concrete must be acid arched or mechanically abraded prior to tiling2. Mixing Mixing ratio of Dr. Fixit Fevimate XL1 bag (20kg.): Water 4.6 Liters Slowly add Dr. Fixit Fevimate XLto a bucket of water for mixing Use a trowel or mechanical mixer (speed at 150-500 RPM) for mixing until a thick creamy consistency is achieved Allow the mixture to stand for 5-10 minutes for chemical slaking and reducing air bubble Remix then use the adhesive and do not add additional water or powder after tile adhesive was set.3.Applications Spread mortar with flat side of trowel to key-in substrate; thenapply additional mortar to a depth sufficient to be notched with suitable trowel that will leave only enough mortar to give 100% contact with back of tile and a subsequent mortar bed of 3mm to 5mm With high lug tiles, "back buttering" may be required to ensure 100% coverage to back of tiles During the setting of tile, it is advisable to occasionally remove a tile to be sure mortar has not skinned over and sufficient transfer is being made. It is also required that tiles be embedded to obtain good transfer of mortar to tile and for proper alignment. Do not adjust tiles in mortar after they have been set past 10-15 minutesile Adhesive for large tiles and low porous tilesS-PI-001 Rev.EN0321August 2019Page 2/3Technical DataSheet Dr.Fixit Fevimate XL4. Cleaning Clean the tools & equipment with potable water immediately after use.Precautions & Limitation Always add powder to liquid and not liquid to powder Clean the tools & equipment with potable water immediately after use. While working in temperature more than 35 OC (95 oF) always dampen the substrate & finish faster Tiling should not be done when surface temperature is below 4 o C Dr.Fixit Fevimate XLshould not be used on painted, metal surfaces, ply & gypsum boards.