Electric Tubular Heater

Product Details

Magma Electric Tubular Heater are the most versatile and the best suited solutions to a large number of applications. Inside the metal tube, a heater coil is embedded and electrically isolated in highly compressed magnesiumoxide. The optimized structure and very high density of the magnesium oxide form the basis for the excellentmechanical and thermal characteristics of the Magma Electric Tubular Heater. They can also be fitted with thermostats and temperature limiters in most applications. Tubular heating elements perform exceptional heat transferby conduction, convection or radiation to heat liquids, air, gases and surfaces. Bends are made to customer requirements.Tubular elements from Magma are factory-configured to almost any shape or size. Custom bending diameters canbe made upon request. Typically using steel, stainless steel, Incoloy, inconel or titanium alloys, tubular elements are often regarded as the foundation of all heating elements. These heating elements have a strong outer sheath to help protect the heater from physical stress and uses high quality alloys to allow efficient heat transfer from resistance coil to your heating medium.Careful selection of materials, precise manufacturing techniques as well as numerous tests and inspections ensurethat our Electric Tubular Heater conform to high quality standards and offer an exceptionally long service life.Tubular heating elements may absorb moisture if they sit idle for a long period of time or get exposed to a humid environment. This might lower the dielectric characteristics of the MgO insulation and cause electrical shorting and premature failure. In order to prove the electrical integrity of a tubular heater, the insulation resistance of each circuit to ground should be checked using a 50 VDC megger. An initial reading of 50,000 ohms or more is acceptable in the field. If heaters do not pass the megohm test they should be dried out. An ideal drying procedure is oven-drying at 375F after removing the terminal hardware. An alternate procedure is to apply a lower voltage (please consult factory for instructions). The target is to attain at least 2 megohms. The two most critical factors that affect the durability of a tubular heater are:  Sheath material  Watt density The sheath material type of a tubular heater depends on the operating temperature and the corrosivity of the medium within which the heater will operate. The watt density distribution on the surface of a tubular heater is critical for two reasons. First it determines the temperature that a heating element sheath will attain within the conditions that the heater is subjected to. The second reason is that every material has a specific maximum watt density that it can tolerate during its heating cycle. Table 1 below lists various sheath materials, maximum allowable temperatures and mediums within which they are recommended to operate. Price Range: 250-15000rs/Unit Sheath Material  Maximum Sheath Temperature Applications  Copper  350 F  Immersion into water and non corrosive low viscosity liquids Steel   750 F Oil, wax, asphalt, cast in aluminum or iron Stainless Steel 304-316  1200F Corrosive liquids, food industry, sterilizers Incoloy 1500 F Air, corrosive liquids, clamped to surfaces