Fairmate Flowgrout 60 Non Shrink Chloride free Cementitious Grout, For Construction, 30 Kg

Product Details

BENEFITS PRODUCT USE DESCRIPTION < Prepacked, factory controlled consistent material needing only addition of water < Shrinkage offset by expansion to ensure original volume is retained < Free flowing, self levelling grout < Easy placement and filling of underbases of machinery < Non metallic and chloride free. < Holds up to industrial machinery vibration & impact. < Extended work time for easy placement. < Excellent adhesion to concrete and steel. < Non staining. < Contains no calcium chloride additives so there can be no rusting or staining of metal contacts or reinforcement. < High ultimate strength and durability. FLOWGROUT 60 is a single pack ready to use, ultra high strength, free flowing, non shrink grout. FLOWGROUT 60 is a blend of specially processed cement and special fillers, free from corrosive substances and additives. FLOWGROUT 60 can be used to Bolt pockets and base plate grouting of all equipment, Crane, stanchion bases and all types of machinery with dynamic load. FLOWGROUT 60 is based on specially processed cement containing fillers and additives. FLOWGROUT 60 is supplied as ready to use grout requiring addition of precise quantity of water at site (3.750 to 4 Litre/25 Kg Grout). FLOWGROUT 60 is suitable for gap widths of between 10mm - 50mm. For width less than 10mm FLOWGROUT EP resin grout can be used (see separate data sheet for more information) for thickness in excess of 50mm. (say 75-100), cleaned washed 10mm aggregates can be incorporated at the rate of 50% - 100% of the quantity of grout used. Low water demand ensures high early strength. PROPERTIES Yield Per 25 kg : 12.5 lit. approx Pourable Life : 20 minutes Expansion: Controlled expansion occurs in the unset material to ensure that the grout, when cured will continue to occupy its original volume within the confines of the voids in which it was placed. For thicker section it is necessary to fill out grout with well graded silt free aggregate to minimize heat build up. Application Temp : 10 ºC to 40 ºC Expansion (% Vol) : 0.8 to 1.5%. Time of Expansion : Start : 20 minutes (after mixing with water) Finish : 120 minutes Flow : 17 to 22 cms on flow table TYPICAL STRENGTH DEVELOPMENT Compressive strength : Average strength (Kg/cm²) at flowable and pourable consistency tested as per BS 1881 : Part 116, 1983. One pack of FLOWGROUT 60 will produce approximately 12.5 litres of grout when mixed with specified quantity of water. Mixing : Mechanical mixing using a grout mixer or freefall concrete mixer is recommended. No hand mixing is permitted.(1) Place 80% of the water required in a concrete mixer [100% in case