Plastic Ekomilk Bond Milk Analyzer, For Laboratory Use, 220V

Product Details

Ekomilk Bond  is robust, reliable, automated multi-parameter milk analyzer providing rapid test results for: Fat, Protein, Solids Not Fat, Lactose, Density, Freezing point, Added Water, Temperature and Conductivity in fresh milk (cow, sheep and/or buffalo, goat). RS-232 & USB interface, Micro printer and automatic data capture are integrated. Based upon ultra-sound technology, the instrument does not require any costly chemicals, caustic or reagents for testing. EKOMILK BOND is an example of accuracy and efficiency of bench chemistry methods. Test results are coming just in 45 seconds! Key feature: Fast Analysis - allows a large number of measurements to be done; Simple and lightweight design; +12V DC and 220V (or 110V optional) AC Power supply; Cost effective: Low power consumption; Very small quantity of milk required; No acid or other chemicals are used; One year full warranty; Measuring accuracy adjustment can be done by the user; RS 232 Interface and Data collection System.Fig. 1. Appearance1. Select the work mode2. Skip and search forward and backwards (Upand Down buttons are active only)3. Confirm the choice4. Tube (sucker)5. Plastic support6. Ultrasonic Processor* START button7. Ultrasonic Processor* Probe (for moreinformation – see Appendix 7 UltrasonicProcessor)8. Cleaning compartment9. Thermal panel printer Back Panel 1. RS 232 Interface outlet2. 12V DC Printer Power Supply outlet3. ON/OFF Switch - for car vehicle use12V4. 12V DC Power supply outlet5. POWER Switch6. AC power led7. USB Interface outlet8. Ultrasonic Processor TimercontrolAnalyzer InstallationPlace the Analyzer on a table or any other flat surface.Place vertically the Analyzer on a table or any other flat surface.Setting of AC Power Supply VoltageConnect the AC power lead first to the analyzer and then to the mains socket.Switch on the AC power.Setting of 12V DC Power Supply VoltageConnect the DC supply lead to 12V input on the analyzer (black is “-”) and then to the autonomous DCsupply (for example car battery).Switch on the DC power.Warm upWhen the power is on, the EON Trading logo and the message WARM UP appears on the display.When the “warm up” stage is over in about 5 minutes, message EKOMILK is shown on the display.The Analyzer is ready to use.Warning:1. The covers of the Analyzer should never be removed while the power leads are connected.2. Under no circumstance should you try to repair the Analyzer’s power lead yourself. In caseof power lead damage, contact your dealer to make the repairs.Remark: Do not take into consideration the first sample because it is likely to be with adeviation out of specification.MILK SAMPLESMilk samples temperature should be between 5 and 35°C. If the milk temperature is above 35°C themessage HOT SAMPLE appears on the display.If you try to test cool (refrigerated) milk which has some milk fat/cream separated you will probably getwrong result especially for the milk fat contents. In this case you need to warm up the milk up to 40 -42°C first, mix the milk in order to solve the separated fat, cool it down to 20 - 25°C and then you cantest it with the EKOMILK Analyzer.The milk acidity of the milk sample must be less than 25°T for cow, buffalo and goat milk and less than28°T for sheep milk.Use the milk sample only once. When the measuring is carried out, throw the sample away.MILK SAMPLE DEAERATION (DEGASSING)See Appendix Ultrasonic Processor for Ultrasonic Processor settings.One of the most common problems of the ultrasonic measurement of milk is the presence of air insidethe milk sample (Please see “Some reasons for EKOMILK accuracy and repeatability deviations”for reference). In order good measurement accuracy and repeatability to be guarantied the milksample must be completely free of air.