Apcorep Inject Grout / Krishna Conchem Epco KP / Hp 250

Service Details

Properties: AKEMI® Standard Acrylic Sealant is a polyacrylate-based, plastic, 1-component dispersion sealant with good adhesion for sealing joints indoors (without permanent humidity). The product is characterized by the following properties: - good working and smoothing properties - hardens by means of physical drying which depends on temperature and weather - neutral odour - free of solvents and silicone - resistant to weathering and ageing - good UV-resistance - forms a skin within approx. 10 minutes - elongation stress up to max. 7.5% - paintable after hardening; due to the large variety of painting systems make a compatibility test firstApplication Area: AKEMI® Standard Acrylic Sealant is used for sealing of joints and connecting joints without elongation stress, e.g. door/window connecting joints to plaster, masonry, concrete, aerated concrete, plasterboard, connections to roller shutter boxes, wooden ceilings, stairs, lightweight walls, in sanitary areas on tile wall/ceiling connection and tile base/wall connection, for the repair of plaster cracks.Instructions for Use: 1. Contact surfaces must be firm, free of dust, grease and rust. They do not necessarily have to be dry, they can be humid, but must not be wet. 2. In order to avoid adhesion on three flanks or in the event of deeper joints use AKEMI® Back-Filling Cords. 3. Use AKEMI® Adhesive Masking Tapes to mask off surfaces in the area of the joint edges. 4. Adheres without primer to many, even absorbent surfaces. On very absorbent surfaces we recommend a prime coat with diluted acrylic resin (diluted with water in the ratio of 1:1 to 1:5). The prime coat should be dry before the joints are sealed. 5. AKEMI® Standard Acrylic Sealant contains water and is therefore sensitive to frost until it has hardened to a large extent. Do not use below +5°C. 6. Apply AKEMI® Standard Acrylic Sealant and smoothen it within 10 minutes with water or AKEMI® Smoothing Agent. 7. Pull of the masking tape used in the direction of the joint before the skin forms. 8. Hardening depends on the thickness of the layer, the temperature and above all on the atmospheric humidity (physical drying). At normal temperatures (20°C/50% RH) AKEMI® Standard Acrylic Sealant forms a firm surface skin after approximately 2 hours and is completely hardened after approximately 1 to 2 weeks. 9. Clean tools with water immediately after finishing work.